|
Solar garden irrigation with a WaterWand and drip
irrigation. Quick set-up guide.
1. Drill
6mm hole in water butt lid, thread inlet tube through, push filter on to end,
adjust length of tube so filter hangs 10cm off bottom. Take other end to pump,
ensure there is some slack, cut clean and square and push onto inlet marked I so that tube is straight and does not pull.
2.
Starting at far end from pump and working back screw/push drippers onto tube,
stake into position, cut tube and screw on tee where next dripper needed, add
piece of tube, dripper and stake.
3.
Repeat until all drippers in place, routing the tube inconspicuously and
clipping into place as you go.
4.
Ensuring a clean square cut and leaving some slack, cut tube and push onto pump
outlet marked O. All connections to pump must be straight and should not pull
against the pump. Support tube if necessary with clips.
5. Turn
pump on to number 3. Allow it 24h to settle. If it then waters too much turn it down, too little turn it up.
Detailed setting up and operating a WaterWand solar
garden irrigation system, pdf download
Please don't hesitate to contact us if you have any queries or comments about our products or how to use them. The telephone is not permanently manned, if you get our answering machine please leave your name and telephone number so we can call you back.
| 
